Simple question:-
As with the AV2, does the NVi come with the reverse cable for connecting to the unity gain input of the preamplifiers?

Kind regards

Allen

Nope.

As it can function on it's own, direct to a power amp, or to a unity gain AV input, you must choose which extras you need and buy them.

Thanks Mike, what you say makes complete sense.

Regards

Allen

BTW,

I'm always being asked:-

n-Vi uses a straight 5:5 lead, not a reverse interconnect.

The reverse interconnect is only used on the AV2 as "AN3" is an input and an output.

Whoooohooo! Thanks AV@naim for that interjection.

That means when my Hi-Line arrives I can use the spare lavender interconnect from the CDS3 for the NVi to 252 link up.

Kind regards

Allen

av@naim
if i was to use another make of processor with phono outs for the fronts what cable would be required to connect this into 552 for unity gain

thanks neil

quote:

Originally posted by neil w:
av@naim
if i was to use another make of processor with phono outs for the fronts what cable would be required to connect this into 552 for unity gain

thanks neil

As far as I recall a 2xphono->5 pin din in to the AV input would do it.

We do supply these cables, but I would ask your dealer to obtain one for you from us.

thanx for the reply av,just to clarify its one single phono per spkr
also what leads for
single phono out into 145 for center
single phono per rear spkr out into 300

cheers neil

quote:

Originally posted by neil w:
thanx for the reply av,just to clarify its one single phono per spkr
also what leads for
single phono out into 145 for center
single phono per rear spkr out into 300

cheers neil

I would hope so. I have yet to get a 2xanalogue signal down 1 phono connector...(without mux'ing)

I presume you are meaning the 552 should be supplied (via its 5 pin AV input) with the L/R (2xphono) front signal from the AV device.

The other leads require 1xphono->XLR. I suggest speaking directly to your dealer on this matter as I cannot clarify that we supply these at present.

More importantly note that:-

145 signal goes in on CH1 (left) pin of the XLR only.

300 signal goes in on CH1 (left) and CH2 (right), so will require the correct leads in the correct sockets for this to work properly.