can any one tell me how to fit naim speaker cable to the nv/i plugs please asap

You have to undo the two screws which hold the two halfs of the plastic-mounting together.
The plastic mounting inself is direction so make note of this before undoing the screws.
On the plastic mounding, there are two little bumps (between the banana plugs), these bumps need to face toward the speaker sockets on the n-Vi.

Solder the NACA5 speaker cable straight into the banana-plugs, which have a slot in the end of the connector. Solder one side then flip it 180 degrees and solder the other side.

Refit the plastic covers and make note of the +/- markings on the plastic covers.

I hope that this is helpful.

thank u ram. did not read your reply till after i had contacted my dealer .he is coming to do it.set up with my plugs last night.it got to run in ,but it was awsome

IS there a problem if the Naim plugs are replaced for standard plugs . . .

brett 10 in the nv/i book naim tell you to use there plugs my dealer thinks the gold banana plugs ive got are better .