![]() | Visit the Naim E-Store |
Topic Closed|
Go
![]() |
New
![]() |
Find
![]() |
Tools
![]() |
|
Member |
There has been much written about CD3.5/flatcap vs CDX.
But has anybody an CD2 and CDX standing for comparison ?. The situation for me is that I downgraded after a couple of years with the CDI, to an CD3. In my previos set-up CDI was a bit corny in treble region which CD3 has’nt. But otherwise I miss some of CDI’s strength. Do I get these in a CD2 as I have been told it has’nt so much CDI grain, or is the road CDX only ? All the best Per |
||
|
|
Senior Member |
Per
If you consider that Naim is a progressive company, then their later offerings should be better at the same price categories. For example, CDi was replaced by CD2, which was replaced by CDX. However, all three models make good music albeit with slightly different strengths and weaknesses. I have listened to CDX and currently own CD2 and I personally find it hard to pick between the two. Do note that the CD2 has 2 variants. The standard model is equipped with a CDM-9 transport. There were some with CDM-9PRO (identified with an all-metal CD spindle), which sounds better. In the end, I think your decision will be tempered with your longer term goals. If you are happy to stop at the CD2/CDX level, the CD2 is a very good buy. Aspiring to CDSII later could be made less painful with the upgradeable CDX route. Good luck. James |
|||
|
|
Member |
James said:
“I have listened to CDX and currently own CD2 and I personally find it hard to pick between the two.” Thats’ a good note James, for me it gives a bit preference for CD2 if I can find any! Thank you James for your thoughtfully advice. Regards |
|||
|
|
1st Timer |
Hi Per,
my investigation on the old forum for s.n of the CD 2 with 9pro : 115.587 - 120.146. These serial numbers were reportet in a thread about CDM 9 vs. CDM 9pro, so the numbers may vary. Best regards, Martin |
|||
|
|
Member |
Thank you Martin
Per |
|||
|
| Previous Topic | Next Topic | powered by eve community |
| Please Wait. Your request is being processed... |
Topic Closed
