hi

i m using this connection scheme:

122x out -> 150x in
fc2 power out -> 122x Upgrade

is there an alternative?


fc2 signal out -> 150x in
fc2 power out -> 122x Upgrade

if so, which one is recommended?

Thanks in advance

The output from your 122x should go the input on the flatcap 2X. One (of the 3) outputs on the back of your flatcap should connect to the 150x.

You should be getting the correct information from your dealer and/or User's Manual.

If you are confused (which you are) over any aspect of use - read this. It can be downloaded from the Products page of the main site.

I think you'll hear a significant improvement after making these changes.
Good Luck and enjoy!

Initialy
i made a mistake trying to find the right connection. i connected 122x out (not upgrade) to fc2 signal out. I tried to play a cd for few seconds...
Is this can damage anything?

Then i asked here and then my dealer...


Now after i make the right connections sound is different: deeper bass, more air and bit dull

my system is
cd5i/122x/150x/fc2/totem hawks

quote:

Now after i make the right connections sound is different: deeper bass, more air and bit dull

Give it a couple of days to come on song. Make sure you leave it on all the time. The 122x/150x/fc2x is a great amp.

Nigel